Modeling & Simulation of Microsystems – Page 42

Modelling of Integrated Peltier Elements

Wijngaards D.D.L., Cretu E., Kong S.H., Wolffenbuttel R.F., DIMES ITS/Et, NL

On-chip integration of Peltier devices creates a number of additional parasitics, compared to conventional Peltier devices. The most important are thermal conduction through the supporting membrane and contact resistance. Analytical analysis shows that each parasitic [...]

Simulation and Experimental Verification of Micro Polymerase Chain Reaction Chip

Lin Y-C., Yang C-C., Hwang M-Y., Chang Y-T., Cheng Kung University, TW

This study used finite element analysis to simulate the temperature characteristics of a micro polymerase chain reaction (PCR) chip. The micro-PCR chip was fabricated on a silicon wafer and Pyrex glass using photolithography, wet etching, [...]

Simulation of Heat-Transfer Enhancement Effects in Microreactors

Hardt S., Ehrfeld W., Hessel V., Vanden Bussche K.M., Institut für Mikrotechnik Mainz GmbH, DE

Sate-of-the-art microstructuring techniques allow to model the interface for heat and mass transfer in miniaturized reactions systems on a micrometer scale. In this context, two different approaches for heat transfer enhancement are presented. The ideas [...]

Thermal Management of Micro-Hotplates using MEMCAD as Simulation Tool

Briand D., Grétillat M.-A., van der Schoot B., de Rooij N.F., Institute of Microtechnology, CH

In this paper we report on the electrothermal simulations performed in the aim of optimising the power consumption and the temperature distribution of micro-hotplates for gas sensing applications. The micro-hotplate designs were optimised using the [...]

Numerical Simulation of Pulse-Width-Modulated Micropumps with Diffuser/Nozzle Elements

Nguyen N-T., Huang X., Nanyang Technological University, SG

This paper presents the numerical simulation of a new control method for dynamic micropumps with diffuser/nozzle elements: the pulse-width-modulation (PWM) of the drive signal. A piezo disk with a square wave signal actuates the pump, [...]

Dynamic Analysis of an Electrostatic Micropump

Jiang T.Y., Ng T.Y., Lam K.Y., National University of Singapore, SG

In this paper, a micropump actuated by electrostatic force is dynamically analysed. Mathematical model is established to evaluate the dynamic response of the micropump. Electro-mechanical coupling effect is considered in evaluating the electrostatic force applied [...]

Applications: Micropumps, Heaters and Coolers

A Comparison of the Behavioral Characteristics of Miniature Gas Flow Sensors

Cousseau P., Dubochet O., Lerch Ph., Renaud Ph., Swiss Federal Institute of Technology, CH

This paper presents a comparison of three different designs for a miniature gas flow sensor operating on the thermal transfer principle, the standard silicon nitride membrane device and two plastic designs. The goal of this [...]

Computational Studies of Membrane-Based Test Formats

Krishnamoorthy S., Makhijani V.B., Lei M., Giridharan M.G., Tisone T., CFD Research Corporation, US

Membrane-based test formats provide simple, accurate and cost effective diagnoses of acute and chronic conditions in general population health. The sensitivity of the immunoassay is determined by the complex biochemical binding kinetics associated with the [...]

Impact of Microdrops on Solid Surfaces for DNA-Synthesis

Maier C., aus der Wiesche S., Hofer E.P., University of Ulm, DE

The miniaturization of chemical synthesis procedures and their integration in complex microfluidic systems is highly interesting both commercially and scientifically. Here, dosing of microdrops for activation or passivation with high accuracy on a substrate or [...]