Koh D. – TechConnect Briefs

Chemical-Free Metal PDMS Thermal Bonding in Flexible Bio-Potential Electrode Fabrication

Koh D., Wang A., Oh K.W., University at Buffalo, US

The flexible bio-potential electrode is gaining signifiacnt interest in wearable or implantable biosensors. Among many soft materials, polydimethylsiloxane (PDMS) is widely studied because of its good biocompatibility and elasticity. However, due to the nature of [...]

Recirculating samples inside chambers using vacuum and centrifugal forces

Wang A., Koh D., Oh K.W., SMALL (Sensors and MicroActuators Learning Lab), Department of Electrical Engineering, The State University of New York at Buffalo, US

In this paper, a combination of vacuum and centrifugal forces was studied for recirculate samples inside the chambers. Detection low concentration samples, rare molecules such as cancer cells or certain proteins among large volume of [...]

Microfluidic Test Target for Photoacoustic Imaging

Schneider P., Eadie N., Christie L., Zhan Y., Siskar T., Koh D., Xia J., Oh K.W., University at Buffalo's Sensors & MicroActuators Learning Lab (SMALL), US

Photoacoustic imaging involves the use of optics (typically a high power pulsed laser) and acoustics (ultrasonics frequency ranges >1MHz) to image a targeted object. Individually, these modalities, being optical and ultrasonic imaging, can be quantified [...]

A compact syringe-assisted vacuum-driven micropumping with a constant flow rate

Wang A., Koh D., Schneider P., Oh K.W., University at Buffalo, US

Abstract In this paper, a simple syringe-assisted pumping method was introduced. Compared with previous study [1], the proposed design does not require pre-designed vacuum chambers, the multiple pumps can be integrated into one device and [...]

3-D electrode configuration for electrochemical impedance spectroscopy of bulk solution

Wang A., Koh D., Schneider P., Oh K.W., University at Buffalo, US

Abstract In this paper, a 3-D electrode configuration for electrochemical impedance spectroscopy (EIS) of a bulk solution was studied. Top- and bottom- electrode configuration, where two electrodes sandwich the sensing channel, was fabricated using the [...]

A Simple Method for Fabrication of Microarrays and Microfluidic Device Using PDMS Stamp

Lee H., Koh D., Oh K.W., SUNY at Buffalo, US

We describe a simple micro-fabrication method by using polydimethylsiloxane (PDMS) stamp on a glass substrate. While the microwells used previously facilitated the cell-to-cell formation by PDMS stamping method, not only should it be carefully controlled [...]

A Simple Method for Fabrication of Microarrays and Microfluidic Device Using PDMS Stamp

Lee H., Koh D., Oh K.W., SUNY at Buffalo, US

We describe a simple micro-fabrication method by using polydimethylsiloxane (PDMS) stamp on a glass substrate. While the microwells used previously facilitated the cell-to-cell formation by PDMS stamping method, not only should it be carefully controlled [...]