Modeling and Control of Nanomirrors for EUV Maskless Lithography

, , ,
,

Keywords: , , , , ,

The design of mirrors for use in EUV maskless lithography is presented in this paper. We propose a novel nanomirror system with a linear comb actuator, which has favorable stability and performance. A bias voltage and resistor are provided to introduce electrical damping while a modulation voltage turns on/off the nanomirror. The issue of transient optimization to minimize the settling time and overshoot of time response is discussed. Two important control parameters are obtained which lead to specification of an optimal resistor and operating position.

PDF of paper:


Journal: TechConnect Briefs
Volume: Technical Proceedings of the 2000 International Conference on Modeling and Simulation of Microsystems
Published: March 27, 2000
Pages: 602 - 604
Industry sector: Sensors, MEMS, Electronics
Topicss: Chemical, Physical & Bio-Sensors, MEMS & NEMS Devices, Modeling & Applications
ISBN: 0-9666135-7-0